Aube-technologies Programmable H/C Controller TH146-P-U Uživatelský manuál stáhnout pdf

TH146-P-U 1/12

TH146-P-U

Installation Guide

Programmable H/C Controller

The TH146-P-U programmable controller can be used with any of

the following heating/cooling systems:

The following devices can be connected to the controller:

 air recirculation fan

 humidifier

 dehumidifier or air exchanger

 dual-register meter (dual energy)

 remote control device (for the unoccupied mode)

• CT280-3H3C control module

• TH146-P console with two wall anchors and mounting screws

• AC144-03 outdoor temperature sensor (3 m or 10 ft) with mount-

ing clip (see section 2.7)

• RC845 relay (see section 2.4)

• AC146-410 plenum temperature sensor (see section 2.8)

• CT241 telephone controller (see section 2.10)

Configure the control module according to your type of heating/cool-

ing system using DIP switches on the back of the module.

Install the control module near the heating/cooling system, away

from any heat source.

Install the console in a central location. Avoid locations with air

drafts (e.g., top of staircase or air outlet) or stagnant air (behind a

door). Do not install the console on a wall hiding air ducts nor

expose it to direct sunlight.

NOTE: If this controller replaces an old thermostat, any two of the

wires that were connected to the thermostat can be used to connect

the user console to the control module. The maximum wiring length

is 30 m (100 ft).

CT280-3H3C Control Module

TH146-P User Console

AC144-03 Outdoor

Temperature Sensor

Removable

Connector *

Removable

Connector *

* To remove a connector from the control module, pry with a screwdriver.

1. Introduction

1.1

Applications

Heat pump

1H1C, 2H1C, 2H2C, 3H1C, 3H2C, 3H3C, 4H2C

HVAC

1H, 2H, 3H, 1C, 2C, 3C, 1H1C, 1H2C, 2H1C, 2H2C,

2H3C, 3H1C, 3H2C, 3H3C

1.2

Supplied Parts

1.3

Accessories

2. Installation

2.1

Control Module (CT280-3H3C)

2.2

User Console (TH146-P)

Heat pump

HVAC

1 2 3 4 5 6 ... 11 12

Shrnutí obsahu

Strany 1 - TH146-P-U

TH146-P-U 1/12TH146-P-UInstallation GuideProgrammable H/C ControllerThe TH146-P-U programmable controll

Strany 2

TH146-P-U 10/12The controller normally displays the measured indoor temperature.To view the setpoint, p

Strany 3

TH146-P-U 11/12NOTE: Skip this section if you do not have a humidifier or a dehu-midifier connected to

Strany 4 - Wiring Tables

TH146-P-U 12/12CT280-3H3C CONTROL MODULEPower supply: 24 VAC Current consumption: 150 mAMaximum load pe

Strany 5

TH146-P-U 2/12 Choose a location about 1.5 m (5 ft) above the floor on an inside wall. Loosen the cap

Strany 6

TH146-P-U 3/12With automatic heating/cooling mode changeover, there’s no need to adjustthe controller a

Strany 7 - Wiring Diagram: 3H2C HVAC

TH146-P-U 4/12Wiring TablesHeat PumpTerminal Device 1H1C 2H1C 3H1C 2H2C 3H2C 4H2C 3H3CTHConsole Connect

Strany 8 - Configuration Menu

TH146-P-U 5/12Wiring Diagram: 2H1C Heat Pump — New InstallationAC146-410AC144-03CT241HumidifierDehumidi

Strany 9

TH146-P-U 6/12Wiring Diagram: 3H2C Heat Pump — Add-on InstallationAC146-410AC144-03CT241FaultDefrostRev

Strany 10 - Automatic Temperature Setting

TH146-P-U 7/12Wiring Diagram: 3H2C HVACAC146-410AC144-03CT241Cooling Unit 1Cooling Unit 2Heating Unit 1

Strany 11

TH146-P-U 8/12Configuration MenuItem HP HVAC Parameters Display Options Default Description1*  Time f

Strany 12 - 12.Technical Assistance

TH146-P-UUser’s GuideProgrammable H/C ControllerTH146-P-U 9/12 Press Clk. The hour display flashes. S

Komentáře k této Příručce

Žádné komentáře

Aube-technologies Programmable H/C Controller TH146-P-U Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Kontrolní panel Aube-technologies Programmable H/C Controller TH146-P-U. Aube Technologies Programmable H/C Controller TH146-P-U User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Kontrolní panel Aube-technologies Programmable H/C Controller TH146-P-U